FRONT SEATBACK HEATER(for 3 Door) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note

Always use "TORX" socket wrench E10 when removing the front seat.

Tech Tips

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

PROCEDURE


  1. INSTALL SEPARATE TYPE FRONT SEATBACK COVER


    1. Engage the 5 hooks to install the separate type front seatback cover (front seatback heater) to the separate type front seatback pad.

  2. INSTALL SEATBACK COVER WITH PAD

    Click here

  3. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY

    Click here

  4. INSTALL REAR SEAT CUSHION INNER SHIELD LH

    Click here

  5. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

    Click here

  6. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)

    Click here

  7. INSTALL FRONT SEAT CUSHION COVER (for LHD)

    Click here

  8. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  9. INSTALL VERTICAL ADJUSTING HANDLE LH (for Driver Side)

    Click here

  10. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  11. INSTALL FRONT SEAT HEADREST ASSEMBLY

    Click here

  12. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  13. INSTALL SEAT TRACK OUTER COVER LH

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  15. INSPECT SRS WARNING LIGHT

    Click here