FRONT SEAT CUSHION HEATER(for 5 Door) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note

Always use E10 "TORX" socket wrench when removing the front seat.

Tech Tips

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

PROCEDURE


  1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER (for TMMF Made)


    1. Engage the 15 hooks to install the separate type front seat cushion cover (front seat cushion heater) to the separate type front seat cushion pad.

  2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER (for TMC Made)


    1. A01VF6PE04
      Text in Illustration
      *1 Hog Ring
      *2 Hog Ring Pliers

      Using hog ring pliers, install the separate type front seat cushion cover (front seat cushion heater) to the separate type front seat cushion pad with 14 new hog rings.

      Note


      • Be careful not to damage the cover.

      • When installing the hog rings, take care to minimize wrinkles as much as possible.

      • Align the center of the hog ring installation area of the separate type front seat cushion cover with the center of the separate type front seat cushion pad so that no wrinkles appear, and securely tighten the hog rings as shown in the illustration.

    2. A01VL2RE03
      Text in Illustration
      *1 Hog Ring
      *2 Hog Ring Pliers

      Using hog ring pliers, install 2 new hog rings.

      Note


      • Be careful not to damage the cover.

      • When installing the hog rings, take care to minimize wrinkles as much as possible.

      • Securely tighten the hog rings as shown in the illustration.

  3. INSTALL SEAT CUSHION COVER WITH PAD

    Click here

  4. INSTALL FRONT SEAT CUSHION INNER SHIELD LH

    Click here

  5. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

    Click here

  6. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)

    Click here

  7. INSTALL FRONT SEAT CUSHION COVER (for LHD)

    Click here

  8. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  9. INSTALL VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)

    Click here

  10. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  11. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  12. INSTALL SEAT TRACK OUTER COVER LH

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  14. INSPECT SRS WARNING LIGHT

    Click here