REAR AIRBAG SENSOR(for 3 Door) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE REAR SEAT ASSEMBLY (for LH Side)

    Click here

  4. REMOVE REAR SEAT ASSEMBLY (for RH Side)

    Click here

  5. REMOVE DECK BOARD ASSEMBLY

    Click here

  6. REMOVE SPARE WHEEL COVER

    Click here

  7. REMOVE NO. 2 ROOM LIGHT ASSEMBLY (for LH Side)

    Click here

  8. REMOVE JACK HANDLE (for RH Side)

  9. REMOVE REAR FLOOR FINISH PLATE

    Click here

  10. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  11. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Click here

  12. REMOVE FRONT SEAT BELT OUTER BAR SUB-ASSEMBLY RH

    Click here

  13. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

    Click here

  14. SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH

    Click here

  15. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

    Click here

  16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

    Click here

  17. REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01VLEM

      Disconnect the connector from the No. 2 side airbag sensor assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push and hold the white housing lock, and slide the outer connector locking sleeve.

        A01VH74E24
        Text in Illustration
        *1 Housing Lock *2 Outer Connector Locking Sleeve
        *a Slide - -

      2. Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.

    4. A01VLZ9

      Remove the bolt and No. 2 side airbag sensor assembly.

      Note

      Loosen the bolt while holding the No. 2 side airbag sensor assembly because the No. 2 side airbag sensor assembly pin (stopper) is easily damaged.