REAR AIRBAG SENSOR(for 5 Door) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

PROCEDURE


  1. INSTALL NO. 2 SIDE AIRBAG SENSOR ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Insert the pin (stopper) into the body hole to install the No. 2 side airbag sensor assembly to the vehicle with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the No. 2 side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the No. 2 side airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the bolt while holding the No. 2 side airbag sensor assembly because the No. 2 side airbag sensor assembly pin (stopper) is easily damaged.

    4. Connect the connector to the No. 2 side airbag sensor assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

        A01VKNQE06
        Text in Illustration
        *1 Outer Connector Locking Sleeve - -
        *a Slide - -

        Tech Tips

        When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.

    5. Check that there is no looseness in the installation parts of the No. 2 side airbag sensor assembly.

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

    Click here

  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

    Click here

  4. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH

    Click here

  5. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

    Click here

  6. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  7. INSTALL REAR FLOOR FINISH PLATE

    Click here

  8. INSTALL JACK HANDLE (for RH Side)

  9. INSTALL NO. 2 ROOM LIGHT ASSEMBLY (for LH Side)

    Click here

  10. INSTALL SPARE WHEEL COVER

    Click here

  11. INSTALL DECK BOARD ASSEMBLY

    Click here

  12. INSTALL REAR SEAT ASSEMBLY (for RH Side)

    Click here

  13. INSTALL REAR SEAT ASSEMBLY (for LH Side)

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  15. INSPECT SRS WARNING LIGHT

    Click here