SIDE AIRBAG SENSOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE FRONT ARMREST BASE UPPER PANEL

    Click here

  4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 5 Door)

    Click here

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 3 Door)

    Click here

  6. REMOVE DOOR SIDE AIRBAG SENSOR


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B0046ZF

      Disconnect the connector from the door side airbag sensor.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.

        B00473QE32
        Text in Illustration
        *a Slide *b Outer Connector Locking Sleeve
        *c Housing Lock - -

      2. Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.

    4. B0047JP

      Remove the bolt and door side airbag sensor.

      Note

      Loosen the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.