CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. INSTALL AIRBAG SENSOR ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Check that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor assembly will cause the airbag to deploy.

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the airbag sensor assembly with the 3 bolts.

      Torque:
      17.5 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • Do not use an airbag sensor assembly that has been dropped.

      • Do not subject the airbag sensor assembly to any impact or force.

      • Check that the carpet does not interfere with the installation plane.

    4. Check that there is no looseness by shaking the airbag sensor assembly.

    5. A01VL77E01
      Text in Illustration
      *1 Lever

      Connect the connector holder to lock the lever.

      Note

      Check that the lever is locked.

    6. A01VIDUE01
      Text in Illustration
      *1 Drip-proof Sheet

      Check that the drip-proof sheet has not been removed and does not cut into the connectors.

  2. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION (W/ VSC)


    1. for TMC Made:


      1. Perform yaw rate sensor zero point calibration Click here.

    2. for TMMF Made:


      1. Perform yaw rate sensor zero point calibration Click here.

  5. INSPECT SRS WARNING LIGHT

    Click here