Click here

FRONT SEAT SIDE AIRBAG ASSEMBLY(for 3 Door GRMN) REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

  • If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note:

Always use "TORX" socket wrench E10 when removing the front seat.

Tip:

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. Click here

    REMOVE FRONT SEAT ASSEMBLY

    Click here

  4. Click here

    REMOVE SEAT COVER STRAP SUB-ASSEMBLY (for Front Passenger Side)

    Click here

  5. Click here

    REMOVE RECLINING ADJUSTER RELEASE HANDLE

    Click here

  6. Click here

    REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)

    Click here

  7. Click here

    REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  8. Click here

    REMOVE FRONT SEAT CUSHION INNER SHIELD

    Click here

  9. Click here

    REMOVE FRONT SEAT BACK BOARD SUB-ASSEMBLY

    Click here

  10. Click here

    REMOVE FRONT SEAT BACK COVER

    Click here

  11. Click here

    REMOVE FRONT SEAT BACK COVER WITH PAD

    Click here

  12. Click here

    REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY


    1. B0047NP

      Disengage the 7 clamps to separate the front seat side airbag wire harness.

    2. B004692

      Disengage the loop fastener.

    3. B00489M

      Disengage the 2 clamps.

    4. B0045Z1

      Remove the 2 nuts and the front seat side airbag assembly.

      CAUTION:

      • The nuts must not be reused.

      • Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.