FRONT SEAT SIDE AIRBAG ASSEMBLY(for 3 Door) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

  • If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note

Always use "TORX" socket wrench E10 when removing the front seat.

Tech Tips

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE SEATBACK COVER WITH PAD

    Click here

  4. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY


    1. A01VKLM

      Disengage the 7 clamps to separate the front seat side airbag wire harness.

    2. A01VIS4

      Disengage the 2 clamps.

    3. A01VGAU

      Remove the 2 nuts and the front seat side airbag assembly LH

      CAUTION:


      • The nuts must not be reused.

      • Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.