FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page SUPPLEMENTAL RESTRAINT SYSTEMS > AIRBAG SYSTEM (w/ VSC) > PRECAUTION).

PROCEDURE


  1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01VIJME02

      Engage the 3 hooks B.

    4. Engage the 3 hooks A to install the instrument panel passenger airbag assembly.

    5. A01VJCH

      Install the 2 screws

  2. INSTALL NO. 2 INSTRUMENT PANEL WIRE

    A01VG0DE01
    Text in illustration
    *1 Locking Button

    1. Connect the airbag connector to the instrument panel passenger airbag assembly.

      Note


      • Do not damage the airbag wire harness when connecting the airbag connector.

      • Securely lock the locking button.

    2. Engage the clamp.

  3. INSTALL NO. 2 HEATER TO REGISTER DUCT

    Click here

  4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSPECT SRS WARNING LIGHT

    (See page SUPPLEMENTAL RESTRAINT SYSTEMS > AIRBAG SYSTEM (w/ VSC) > DIAGNOSIS SYSTEM)