KNEE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page SUPPLEMENTAL RESTRAINT SYSTEMS > AIRBAG SYSTEM (w/ VSC) > PRECAUTION).

PROCEDURE


  1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01VL5WE01
      Text in Illustration
      *1 Locking Button

      Connect the airbag connector.

    4. Push in the locking button to the lower No. 1 instrument panel airbag assembly.

      Note

      Securely lock the locking button.

    5. Engage the 6 claws and install the lower No. 1 instrument panel airbag assembly.

    6. Install the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  3. INSTALL LOWER STEERING COLUMN COVER

    Click here

  4. INSTALL STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSPECT SRS WARNING LIGHT

    (See page SUPPLEMENTAL RESTRAINT SYSTEMS > AIRBAG SYSTEM (w/ VSC) > DIAGNOSIS SYSTEM)