STEERING PAD(for TMMF Made) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE


  1. INSTALL STEERING PAD (except GRMN)


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B0047DUC01
      *1 Locking Button

      Connect the airbag connector.

      Note

      Do not use a steering pad that has been dropped.

    4. Push in the locking button.

      Note


      • Do not damage the airbag wire harnesswhen connecting the airbag connector.


      • Securely lock the locking button.

    5. Connect the horn terminal.

    6. B00471G

      Place the steering pad into the steering wheel.

    7. B0046J2E02

      Gently push the A position shown in the illustration until the steering pad is in contact with the steering wheel cover.

      Note

      Do not push the center position of the steering pad.

      Tech Tips

      Pay attention to the correct hand position. Make sure the upper 2 retaining hooks will engage with the retaining clips properly.

    8. B0047XJE02

      While pushing the cover in the steering wheel hub direction (A arrow), gently pull the steering pad in the direction of the B arrow and hold it there then push the bottom edge of the steering pad in the A arrow direction.

      Tech Tips


      • Make sure the upper 2 retaining hooks engage properly.

      • Position your hand on the A area.

      • The steering pad cover must contact with the lower spoke of the steering as indicated with the B circle.

        B00471XE01

  2. INSTALL STEERING PAD (for GRMN)


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B0046KJC01
      *1 Locking Button

      Connect the airbag connector.

      Note

      Do not use a steering pad that has been dropped.

    4. Push in the locking button.

      Note


      • Do not damage the airbag wire harnesswhen connecting the airbag connector.


      • Securely lock the locking button.

    5. Connect the horn terminal.

    6. B0045IV

      Engage the 3 pins with the 3 snap rings to install the steering pad.

      Note

      Pull the steering pad to ensure that it is securely engaged.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER (for GRMN)


    1. Insert the guide and engage the claw to install the lower No. 2 steering wheel cover.

  4. INSTALL LOWER NO. 3 STEERING WHEEL COVER (for GRMN)


    1. Insert the guide and engage the claw to install the lower No. 3 steering wheel cover.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. INSPECT SRS WARNING LIGHT

    Click here