CURTAIN SHIELD AIRBAG ASSEMBLY(for 5 Door) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B00479WE04
      Text in illustration
      *1 Clip
      *2 Pin
      *3 Spacer
      *4 Airbag
      *5 Body Side

      Install 6 new clips and 6 new spacers to the curtain shield airbag assembly as shown in the illustration.

      Tech Tips


      • Do not push in the pin.

      • Make sure that the clips are installed in the correct direction.

      • Make sure that the spacers are installed properly, in the correct direction, and that they are not damaged.

    4. B00486WE01
      Text in illustration
      *1 Hook A
      *2 Hook B

      Engage hook A by inserting it while sliding in the direction shown in the illustration, then engage hook B by inserting it from the direction shown in the illustration, and temporarily install the curtain shield airbag RH with the bolt.

    5. B00481OE03
      Text in illustration
      *1 Pin
      *2 Clip
      *3 Airbag
      *4 Body Panel

      Push in the 6 pins to install the 6 clips and the curtain shield airbag assembly to the body panel as shown in the illustration.

      Note

      Make sure that the pins of the clips are pushed in firmly.

    6. Mark the clips.

      Tech Tips

      Mark the clips to make sure that they are not reused.

    7. Tighten the bolt.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    8. B0045GIE01
      Text in illustration
      *1 Locking Button

      Connect the airbag connector.

    9. Push in the locking button.

      Note


      • Do not damage the airbag wire harness when connecting the airbag connector.

      • Securely lock the locking button.

  2. INSTALL ROOF HEADLINING ASSEMBLY (for TMC Made)

    Click here

  3. INSTALL ROOF HEADLINING ASSEMBLY (for TMMF Made)

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  5. INSPECT SRS WARNING LIGHT

    Click here