PERSONAL LIGHT INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY


    1. A01VLEZE01
      Text in Illustration
      *a

      Component without harness connected

      (Map Light Assembly)

      Apply battery voltage to the connector and check the map light comes on.

      OK
      Measurement Condition Switch Condition Specified Condition

      Battery positive (+) → 3

      Battery negative (-) → 1

      		 All Switch off All light not comes on

      Battery positive (+) → 3

      Battery negative (-) → 2

      		 All Switch off All light not comes on

      Battery positive (+) → 3

      Battery negative (-) → 1

      Center Switch off

      LH Side Switch on

      		 LH Side light comes on

      Battery positive (+) → 3

      Battery negative (-) → 1

      Center Switch off

      RH Side Switch on

      		 RH Side light comes on

      Battery positive (+) → 3

      Battery negative (-) → 1

      LH Side Switch off

      RH Side Switch off

      Center Switch on

      		 All light comes on

      Battery positive (+) → 3

      Battery negative (-) → 2

      LH Side Switch off

      RH Side Switch off

      Center Switch DOOR

      		 All light comes on

      If the result is not as specified, replace the map light blub or map light assembly.