RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT DOME RELAY (for TMMF Made)


    1. A01VLEW

      Remove the DOME relay from the No. 2 engine room relay block.

    2. Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the DOME relay.