| DTC Code | Detection Item | DTC Output Confirmation Operation | See page |
|---|---|---|---|
| B2271 | Ignition Hold Monitor Malfunction | Turn the engine switch on (IG). | |
| B2274 | ACC Monitor Malfunction | Wait 10 seconds after turning the engine switch on (ACC) or on (IG), and then wait another 10 seconds after turning the engine switch off. | |
| B2277 | Detecting Vehicle Submersion | Wait 300 seconds after connecting the cable to the negative (-) battery terminal. | |
| B2282 | Vehicle Speed Signal Malfunction | Drive the vehicle for 20 seconds at a vehicle speed of 25 km/h (16 mph) or more, and then drive the vehicle at a vehicle speed of less than 5 km/h (3 mph) for 20 seconds. | |
| B2283 | Vehicle Speed Sensor Malfunction | Run the engine at an engine speed of 2000 rpm or more for 330 seconds. | |
| B2284 | Brake Signal Malfunction | Connect the cable to the negative (-) battery terminal, release the brake pedal and wait 20 seconds or more. Then depress the brake pedal for 20 seconds or more. |
|
| B2285 | Steering Lock Position Signal Circuit Malfunction | Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and then reconnect the cable to the negative (-) battery terminal. Wait 40 seconds or more with the engine switch off (with the steering wheel locked), then turn the engine switch on (ACC) (with the steering wheel unlocked) and wait 40 seconds or more. | |
| B2286 | Runnable Signal Malfunction | Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and reconnect the cable to the negative (-) Battery terminal. Wait 20 seconds or more with the engine switch off, then start the engine and maintain an engine speed of 1000 rpm or more for 20 seconds or more after starting the engine. |
|
| P0335 | Crankshaft Position Sensor "A" Circuit | Allow the engine to idle for 10 seconds or more with the engine idling. | |
| U0100 | Lost Communication with ECM | Turn the engine switch on (IG) and wait 10 seconds or more. | |
| U0140 | Lost Communication with Body Control Module | Always | |
| U0142 | Lost Communication with Body Control Module "B" | Always | |
| U0155 | Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) | Turn the engine switch on (IG) and wait 10 seconds or more. | |
| U1103 | Lost Communication with Stop and Start Control Module | Turn the engine switch on (IG) and wait 10 seconds or more. |