ENTRY AND START SYSTEM(for Start Function) DIAGNOSTIC TROUBLE CODE CHART

DTC Code Detection Item DTC Output Confirmation Operation See page
B2271 Ignition Hold Monitor Malfunction Turn the engine switch on (IG).

Click here

B2274 ACC Monitor Malfunction Wait 10 seconds after turning the engine switch on (ACC) or on (IG), and then wait another 10 seconds after turning the engine switch off.

Click here

B2277 Detecting Vehicle Submersion Wait 300 seconds after connecting the cable to the negative (-) battery terminal.

Click here

B2282 Vehicle Speed Signal Malfunction Drive the vehicle for 20 seconds at a vehicle speed of 25 km/h (16 mph) or more, and then drive the vehicle at a vehicle speed of less than 5 km/h (3 mph) for 20 seconds.

Click here

B2283 Vehicle Speed Sensor Malfunction Run the engine at an engine speed of 2000 rpm or more for 330 seconds.

Click here

B2284 Brake Signal Malfunction

Connect the cable to the negative (-) battery terminal, release the brake pedal and wait 20 seconds or more.

Then depress the brake pedal for 20 seconds or more.

Click here

B2285 Steering Lock Position Signal Circuit Malfunction Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and then reconnect the cable to the negative (-) battery terminal. Wait 40 seconds or more with the engine switch off (with the steering wheel locked), then turn the engine switch on (ACC) (with the steering wheel unlocked) and wait 40 seconds or more.

Click here

B2286 Runnable Signal Malfunction

Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and reconnect the cable to the negative (-) battery terminal.

Wait 20 seconds or more with the engine switch off, then start the engine and maintain an engine speed of 1000 rpm or more for 20 seconds or more after starting the engine.

Click here

B228A Engine Speed Signal Circuit

Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and reconnect the cable to the negative (-) battery terminal.

Wait 20 seconds or more with the engine switch off, then start the engine and maintain an engine speed of 1000 rpm or more for 20 seconds or more after starting the engine.

Click here

P0335 Crankshaft Position Sensor "A" Circuit Allow the engine to idle for 10 seconds or more with the engine idling.

Click here

U0100 Lost Communication with ECM Turn the engine switch on (IG) and wait 10 seconds or more.

Click here

U0140 Lost Communication with Body Control Module Always

Click here

U0142 Lost Communication with Body Control Module "B" Always

Click here

U0155 Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) Turn the engine switch on (IG) and wait 10 seconds or more.

Click here

U1103 Lost Communication with Stop and Start Control Module Turn the engine switch on (IG) and wait 10 seconds or more.

Click here