REAR DOOR LOCK INSTALLATION

PROCEDURE


  1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)


    1. Engage the guide to install the rear door inside locking cable assembly to the rear door lock assembly.

    2. A0049MS

      Engage the 4 claws to close the cover.

  2. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)


    1. Engage the guide to install the rear door inside locking cable assembly to the rear door lock assembly.

    2. A0047EK

      Engage the 3 claws to close the cover.

  3. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)


    1. Engage the guide to install the rear door lock remote control cable assembly to the rear door lock assembly.

    2. A004BJY

      Engage the 2 claws to close the cover.

  4. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)


    1. Engage the guide to install the rear door lock remote control cable assembly to the rear door lock assembly.

    2. A004B79

      Engage the 2 claws to close the cover.

  5. INSTALL REAR DOOR LOCK ASSEMBLY

    Note


    • If reusing the rear door lock assembly that has been removed, replace the door lock wire harness seal with a new seal.

    • Make sure that no grease or dirt adheres to the door lock wire harness seal surface.

    • Reusing the door lock wire harness seal or using a damaged door lock wire harness seal may cause water intrusion to the connection. This may result in a malfunction of the rear door lock assembly.


    1. Apply MP grease to the sliding parts of the rear door lock assembly.

    2. Install a new door lock wire harness seal to the rear door lock assembly.

    3. A00484FE02
      Text in Illustration
      *1 Release Plate

      Install the rear door lock assembly to the release plate as shown in the illustration.

      Tech Tips

      Make sure that the release plate is securely connected to the rear door lock assembly.

    4. Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    5. Connect the connector.

  6. INSTALL REAR DOOR GLASS RUN

    Click here

  7. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  8. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

  9. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

    Click here

  12. INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

    Click here

  13. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  14. INSTALL REAR DOOR FRAME GARNISH

    Click here