TRANSMITTER BATTERY(w/o Entry and Start System) REPLACEMENT

PROCEDURE


  1. REMOVE TRANSMITTER HOUSING COVER

    Click here

  2. REMOVE TRANSMITTER BATTERY


    1. A01UXI8E01
      Text in Illustration
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, remove the transmitter battery.

      Note


      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter assembly from being damaged.

      • Do not push the terminals with your finger.

      • Do not use excessive force when prying up the battery as this may damage the terminals.

      • Do not touch the transmitter battery with wet hands. Water may cause it to rust.

      • Do not touch or move any components inside the transmitter as this may interfere with its proper operation.

  3. INSTALL TRANSMITTER BATTERY


    1. A01V0DP

      Install the transmitter battery as shown in the illustration.

      Note


      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

      • Make sure that the positive (+) side and the negative (-) side of the transmitter battery are correctly matched with the transmitter terminals.

      • Do not bend the transmitter battery electrode during insertion.

      • Keep the transmitter cover interior free of dust and oil.

  4. INSTALL TRANSMITTER HOUSING COVER

    Click here