REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the RH side.

PROCEDURE


  1. REMOVE REAR DOOR FRAME GARNISH

    Click here

  2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  3. REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

    Click here

  4. REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

    Click here

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  7. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

  8. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  9. REMOVE REAR DOOR GLASS RUN

    Click here

  10. REMOVE REAR DOOR LOCK ASSEMBLY


    1. A01VH9M

      Disconnect the connector.

    2. Using a T30 "TORX" wrench, remove the 3 screws.

    3. A01VFEZE01
      Text in Illustration
      *1 Release Plate
      A01VL3H Slide Direction

      Slide the rear door lock downward, and remove the rear door lock from the release plate.

    4. A01VIZR

      Remove the door lock wire harness seal from the rear door lock.

  11. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY


    1. A01VF3EE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws.

    2. A01VKAC

      Remove the rear door lock remote control cable from rear door lock.

  12. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY


    1. A01VJ7NE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws.

    2. A01VIHN

      Remove the rear door inside locking cable from rear door lock.