NETWORK GATEWAY ECU(for GRMN) INSTALLATION

PROCEDURE

1. INSTALL NETWORK GATEWAY ECU

   
   

   1. Install the network gateway ECU to the junction block bracket with the 2 nuts.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

   2. Connect the 3 connectors.

2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for LHD)

   Click here

3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

   Click here

4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)

   Click here

5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

   Click here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Torque:

   5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.