BATTERY CURRENT SENSOR(w/ Stop And Start System) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY STATE SENSOR ASSEMBLY


    1. A004A5D

      Remove the nut to disconnect the engine wire from the battery state sensor assembly.

    2. A0048Z1

      Loosen the nut and disconnect the battery state sensor assembly from the battery.

    3. A0048GG

      Disconnect the battery state sensor assembly connector.

    4. Disengage the clamp and disconnect the engine wire from the battery state sensor assembly.

    5. A0047S4

      Disengage the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.