BATTERY CURRENT SENSOR(w/ Stop And Start System) INSTALLATION

PROCEDURE

1. INSTALL BATTERY STATE SENSOR ASSEMBLY

   
   

   1. Engage the 2 claws and install the battery state sensor assembly to the battery current sensor holder.

   2. Engage the clamp and connect the engine wire to the battery state sensor assembly.

   3. Connect the battery state sensor assembly connector.

   4. Connect the battery state sensor assembly to the battery and tighten the nut.

      Torque:

      5.4 N*m  { 55 kgf*cm, 4 ft.*lbf }

   5. Connect the engine wire to the battery state sensor assembly with the nut.

      Torque:

      7.5 N*m  { 76 kgf*cm, 6 ft.*lbf }

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Torque:

   5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here