GENERATOR(for DENSO Made) INSTALLATION

Click here Click here

PROCEDURE

1. Click here

   INSTALL GENERATOR ASSEMBLY

   
   

   1. Install the 2 wire harness clamp brackets to the generator assembly with the 2 bolts.

      8.4 N*m

      86 kgf*cm

      74 in.*lbf

   2. 

      Temporarily install the generator assembly and generator bracket to the timing chain cover sub-assembly with the 3 bolts.

   3. Tighten the 3 bolts in the sequence shown in the illustration.

      Bolt (A)
      54 N*m	551 kgf*cm	40 ft.*lbf
      Bolt (B)
      34 N*m	347 kgf*cm	25 ft.*lbf

   4. Connect the compressor with pulley assembly connector.

   5. Engage the 2 clamps to connect the wire harness to the 2 wire harness clamp brackets.

   6. Connect the wire harness to terminal B with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   7. Install the terminal cap.

2. Click here

   INSTALL FAN AND GENERATOR V BELT

   (Click here)

3. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   5.4 N*m

   55 kgf*cm

   48 in.*lbf

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).