NAVIGATION SYSTEM Parking Brake Switch Circuit

DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

B0046Z4E04
*a Parking Brake Switch Assembly
*b Radio and Display Receiver Assembly

PROCEDURE


  1. CHECK VEHICLE SIGNAL


    1. B0047WT

      Enter the "Vehicle Signal Check Mode" screen.

      Refer to Check Vehicle Signal in Operation Check Click here

    2. Check that the display changes between ON and OFF according to the parking brake operation.

      OK
      Parking Brake Position Display
      Applied ON
      Released OFF

      Tech Tips

      This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.


    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. INSPECT PARKING BRAKE SWITCH ASSEMBLY


    1. Remove the parking brake switch assembly Click here.

    2. Inspect the parking brake switch assembly Click here.


    NG

    REPLACE PARKING BRAKE SWITCH ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)


    1. Disconnect the F115 radio and display receiver assembly connector.

    2. Disconnect the F22 parking brake switch assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F47-15(PKB) - F22-1 Always Below 1 Ω
      F47-15 (PKB) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR