NOISE FILTER REMOVAL

Click here

PROCEDURE

1. Click here

   REMOVE DOOR CONTROL RECEIVER (for 5 Door)

   (Click here)

2. Click here

   REMOVE DOOR CONTROL RECEIVER (for 3 Door)

   (Click here)

3. Click here

   REMOVE RADIO SETTING CONDENSER

   Note:

   When the terminal cover is removed, the condenser must be replaced because the terminal cover and condenser are supplied as a set.

   
   
   1. 

      Remove the bolt.

   2. Disengage the clamp and disconnect the condenser with the wire harness from the vehicle body.

   3. 

      Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the terminal cover with the wire harness from the condenser.

      Table 1. Text in Illustration

      *1	Protective Tape

   4. 

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

   5. Remove the terminal cover from the wire harness.