REAR DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the RH side.

PROCEDURE


  1. REMOVE REAR DOOR FRAME GARNISH

    Click here

  2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  3. REMOVE REAR DOOR ARMREST BASE PANEL UPPER (w/o Power Window)

    Click here

  4. REMOVE REAR DOOR ARMREST BASE PANEL UPPER (w/ Power Window)

    Click here

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. REMOVE REAR SPEAKER ASSEMBLY


    1. A01VJO8

      Disconnect the connector.

    2. A01VJDC

      Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the rear door panel.

    3. Operate the drill around the rivet head circumference and cut out the flange.

      CAUTION:

      Be careful. The cut rivet is very hot.

      Note

      Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

    4. After drilling out the flange, continue drilling to push out the shards on the drill.

    5. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.