AUDIO AND VISUAL SYSTEM(for Radio and Display Type) Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

B0047JXE11
*a Shielded
*b No. 1 Stereo Jack Adapter Assembly
*c Radio and Display Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the F119 radio and display receiver assembly connector.

    2. Disconnect the F53 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F119-2 - F53-2 Always Below 1 Ω
      F119-3 - F53-3
      F119-2 - Body ground Always 10 kΩ or higher
      F119-3 - Body ground
      F119-5 - Body ground

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR