AUDIO AND VISUAL SYSTEM(for Radio and Display Type) Steering Pad Switch Circuit

DESCRIPTION

This circuit sends an operation signal from the steering pad switch to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch.

If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

A01VHIKE14

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution in the Supplemental Restraint System Click here.

PROCEDURE


  1. INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Remove the steering pad switch assembly Click here.

    2. Inspect the steering pad switch assembly Click here.


    NG
    OK
  2. INSPECT SPIRAL CABLE SUB-ASSEMBLY


    1. Remove the spiral cable sub-assembly Click here.

    2. Inspect the spiral cable sub-assembly Click here.


    NG
    OK
  3. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)


    1. Disconnect the F115 radio and display receiver assembly connector.

    2. Disconnect the F5 spiral cable sub-assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F115-21 (SW1) - F5-6 (AU1) Always Below 1 Ω
      F115-22 (SW2) - F5-5 (AU2)
      F115-23 (SWG) - F5-4 (EAU)
      F115-21 (SW1) - Body ground Always 10 kΩ or higher
      F115-22 (SW2) - Body ground
      F115-23 (SWG) - Body ground

    OK
    NG