REAR DOOR OUTSIDE MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR OUTSIDE MOULDING


    1. Clean the vehicle body surface.


      1. Using an infrared light, heat any new rear door outside moulding and adhesive remaining on the vehicle body.

        Heating Temperature
        Item Temperature
        Vehicle Body 40 to 60°C (104 to 140°F)

        CAUTION:

        Do not burn yourself on the hot rear door panel or with the infrared light.

        Note

        Do not heat the vehicle body excessively.

      2. Using a piece of cloth, rub the remaining rear door outside moulding and adhesive off the vehicle body.

      3. Using a non-residue solvent, clean the attachment surface.

    2. A01VFP6E04
      Text in Illustration
      *1 Double-sided Adhesive Tape

      Install the rear door outside moulding as shown in the illustration.

      Installation Position
      Mark Measurement (along surface)
      A 10.0 mm (0.393 in.)
      B 3.0 to 7.0 mm (0.119 to 0.275 in.)

      Note

      Install the rear door outside moulding in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F), using an infrared light, heat the rear door panel sub-assembly and the rear door outside moulding to 20 to 30°C (68 to 86°F) and install the rear door outside moulding.