NAME PLATE INSTALLATION

PROCEDURE


  1. INSTALL SYMBOL EMBLEM

    Click here

  2. INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE


    1. Clean the attachment surface.


      1. Using an infrared light, heat the double-sided tape remaining on the back door panel.

        Heating Temperature
        Item Temperature
        Back Door Panel 40 to 60°C (104 to 140°F)

        CAUTION:

        Do not burn yourself on the hot body panel or with the infrared light.

        Note

        Do not heat the back door panel excessively.

      2. Using a piece of cloth, rub the double-sided tape off the back door panel while it is hot from the infrared light.

        Note

        Installing the No. 2 luggage compartment door name plate while any double-sided tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided tape.

      3. Using a non-residue solvent, clean the attachment surface.

    2. Install the No. 2 luggage compartment door name plate as shown in the illustration.

      A0048WDC01
      *a Reference Values *b Edge of Back Door Panel
      Installation Position
      Area Measurement Area Measurement
      A 180.9 mm (7.122 in.) B 43.0 mm (1.692 in.)
      C 69.8 mm (2.748 in.) D 95.1 mm (3.744 in.)

      Note

      Install the No. 2 luggage compartment door name plate in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F), using an infrared light, heat the back door panel and the No. 2 luggage compartment door name plate to 20 to 30°C (68 to 86°F) and install the No. 2 luggage compartment door name plate.