REAR SPOILER(for GRMN) INSTALLATION

PROCEDURE

1. INSTALL REAR SPOILER SUB-ASSEMBLY

   
   

   1. Clean the attachment surface.

      
      

      1. Using an infrared light, heat the double-sided adhesive tape remaining on the back door panel.

         Heating Temperature

         Item	Temperature
         Vehicle Body	40 to 60°C (104 to 140°F)

         CAUTION:

         Do not burn yourself on the hot back door panel or with the infrared light.

         Note

         Do not heat the back door panel excessively.

      2. Using a piece of cloth, rub the remaining double-sided tape off the back door panel while it is hot from the infrared light.

         Note

         Installing the rear spoiler while any double-sided tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

      3. Using a non-residue solvent, clean the attachment surface.

   2. Install the 2 screws.

   3. install the 2 bolts.

   4. Install the new cover.

      Tech Tips

      Use the same procedures for the opposite side.

   5. Install the 2 nuts.

2. INSTALL REAR SPOILER COVER LH

   
   

   1. 

      Engage the 2 claws and install the rear spoiler cover.

3. INSTALL REAR SPOILER COVER RH

   Tech Tips

   Use the same procedure as for the LH side.

4. INSTALL REAR LIGHT COVER

   Click here