REAR COIL SPRING INSTALLATION

PROCEDURE


  1. INSTALL REAR COIL SPRING LH


    1. Install the rear coil spring lower insulator LH onto the rear axle beam assembly.

    2. A01VL5NE02
      Text in Illustration
      *a Fit

      Install the rear coil spring upper insulator LH so that its gap fits onto the end of rear coil spring LH.

    3. A01VJX0

      Install the rear coil spring LH onto the rear axle beam assembly.

      Text in Illustration
      A01VEA4 Paint Mark

      Note

      The paint mark of the rear coil spring LH should be towards the underside and rear side of the vehicle.

  2. INSTALL REAR COIL SPRING RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  3. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH


    1. Support the rear axle beam assembly with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.

    2. Jack up the rear axle beam assembly slowly, and provisionally install the rear shock absorber assembly LH (lower side) with the bolt and nut onto the rear axle beam assembly.

  4. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  5. INSTALL REAR FLEXIBLE HOSE LH


    1. Connect the rear flexible hose LH onto the rear axle beam assembly with a new clip.

    2. Using a union nut wrench (10 mm), separate the brake tube while holding the rear flexible hose LH with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

  6. INSTALL REAR FLEXIBLE HOSE RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  7. INSTALL SKID CONTROL SENSOR WIRE LH


    1. Install the skid control sensor wire LH onto the rear axle beam assembly with the nut.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    2. Connect the skid control sensor wire LH connector.

  8. INSTALL SKID CONTROL SENSOR WIRE RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  9. STABILIZE SUSPENSION

    Click here

  10. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  11. FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY

    Click here

  12. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

    Click here

  13. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  14. BLEED BRAKE LINE (for TMC Made)

    Click here

  15. BLEED BRAKE LINE (for TMMF Made)

    Click here

  16. BLEED CLUTCH LINE (for Manual Transaxle)


  17. INSPECT REAR WHEEL ALIGNMENT

    Click here

  18. CHECK SPEED SENSOR SIGNAL (w/o VSC)

    Click here

  19. CHECK SPEED SENSOR SIGNAL (for TMC Made with VSC)

    Click here

  20. CHECK SPEED SENSOR SIGNAL (for TMMF Made with VSC)

    Click here