FRONT LOWER SUSPENSION ARM REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side as for the LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. REMOVE CENTER ENGINE UNDER COVER (for 1ND-TV)

  3. REMOVE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY

    A000J8H

    1. Remove the clip and castle nut.

    2. B0048AEE05

      Install SST to the threaded section of the lower ball joint.

      SST
      09960-20010   ( 09961-02060 )

      Note

      Make sure the upper ends of the threaded section of the lower ball joint and SST are aligned.

    3. Using SST, separate the front lower suspension arm sub-assembly from the front axle assembly.

      B00488NE02
      Text in Illustration
      *a Place the wrench here - -
      B0046MU Apply grease to the bolt threads and the tip of SST. - -
      SST
      09960-20010   ( 09961-02010 )

      Note


      • Make sure to tie the string of SST to the vehicle to prevent SST from dropping.

      • Install SST so that A and B are parallel.

      • Be sure to place the wrench on the part indicated in the illustration.

      • Do not damage the lower ball joint dust cover.

      • Do not damage the drive shaft outboard joint boots.

      • Do not damage the front disc brake dust cover.

    4. B0047BK

      Remove the 2 bolts and front lower suspension arm sub-assembly.