REAR AXLE HUB(for TMC Made) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side as for the LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the axle hub and bearing onto the axle beam with the 4 bolts.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

  2. INSPECT REAR AXLE HUB BEARING BACKLASH

    Click here

  3. INSPECT REAR AXLE HUB RUNOUT

    Click here

  4. CONNECT SKID CONTROL SENSOR WIRE

    Click here

  5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

  6. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  7. INSPECT REAR WHEEL ALIGNMENT

    Click here

  8. CHECK SPEED SENSOR SIGNAL (w/o VSC)

    Click here

  9. CHECK SPEED SENSOR SIGNAL (w/ VSC)

    Click here