REAR AXLE HUB BOLT(for TMC Made) REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side as for the LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

  3. REMOVE REAR AXLE HUB BOLT


    1. A01VI2EE03
      Text in Illustration
      *a Hold
      *b Turn

      Using SST and a screwdriver or the equivalent, remove the axle hub bolt.

      SST
      09628-10011

  4. INSTALL REAR AXLE HUB BOLT


    1. A01VEZNE03
      Text in Illustration
      *1 Washer
      *2 Nut
      *a Hold
      *b Turn

      Install the washer and the nut onto a new axle hub bolt, as shown in the illustration.

      Recommended Service Nut
      Thread Diameter Thread Pitch
      12.0 mm (0.472 in.) 1.5 mm (0.0591 in.)

      Tech Tips

      Recommended thickness of the washer is 5 mm (0.197 in.) or more.

    2. Using a screwdriver or the equivalent to hold the axle hub, install the axle hub bolt by tightening the nut.

  5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

  6. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }