FRONT DRIVE SHAFT ASSEMBLY(for 2ZR-FE) REMOVAL

PROCEDURE


  1. REMOVE ENGINE UNDER COVER LH

    Click here

  2. REMOVE ENGINE UNDER COVER RH

    Click here

  3. DRAIN TRANSAXLE OIL

    Click here

  4. REMOVE FRONT WHEEL

  5. REMOVE FRONT AXLE SHAFT NUT LH

    Click here

  6. REMOVE FRONT AXLE SHAFT NUT RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  7. SEPARATE FRONT SPEED SENSOR LH

    Click here

  8. SEPARATE FRONT SPEED SENSOR RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  9. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH

    Click here

  10. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  11. SEPARATE TIE ROD END SUB-ASSEMBLY LH

    Click here

  12. SEPARATE TIE ROD END SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  13. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

    Click here

  14. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  15. SEPARATE FRONT AXLE ASSEMBLY LH

    Click here

  16. SEPARATE FRONT AXLE ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  17. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

    Tech Tips

    Measure the size of the gap between the front drive inboard joint assembly and transaxle, and use the measured value for reference when installing.


    1. B00481KE06

      Using SST, remove the drive shaft as shown in the illustration.

      SST
      09520-01010
      09520-24010   ( 09520-32040 )

      Note


      • Do not damage the oil seal.

      • Do not damage the inboard joint boot.

      • Do not drop the drive shaft.

  18. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Measure the size of the gap between the front drive inboard joint assembly and transaxle, and use the measured value for reference when installing.


    1. B0045BM

      Using a tire lever and brass bar, remove the drive shaft.

      Note


      • Do not damage the oil seal.

      • Do not damage the inboard joint boot.

      • Do not drop the drive shaft.

  19. FIX FRONT AXLE ASSEMBLY

    B0046JWE01
    SST
    09608-16042   ( 09608-02021, 09608-02041 )

    Tech Tips

    The hub bearing could be damaged if it is subjected to the vehicle's full weight, such as when moving the vehicle with the drive shaft removed. If it is absolutely necessary to place the vehicle's full weight on the hub bearing, first support it with SST.