FRONT DRIVE SHAFT ASSEMBLY(for 1ND-TV) INSTALLATION

PROCEDURE

1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

   

   
   

   1. Coat the spline of the inboard joint with gear oil.

   2. Align the inboard joint splines and install the drive shaft with a screwdriver and hammer.

      Note

      
      

      • Face the cut area of the front drive shaft hole snap ring downward.

      • Do not damage the oil seal.

      • Do not damage the inboard joint boot.

      Tech Tips

      Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.

2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

3. INSTALL FRONT AXLE ASSEMBLY LH

   Click here

4. INSTALL FRONT AXLE ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

5. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

   Click here

6. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

7. INSTALL TIE ROD END SUB-ASSEMBLY LH

   Click here

8. INSTALL TIE ROD END SUB-ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

9. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

   Click here

10. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

11. INSTALL FRONT SPEED SENSOR LH

    Click here

12. INSTALL FRONT SPEED SENSOR RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

13. INSTALL FRONT AXLE SHAFT NUT LH

    Click here

14. INSTALL FRONT AXLE SHAFT NUT RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

15. ADD TRANSAXLE OIL (for Manual Transaxle)

    Click here

16. ADD TRANSAXLE OIL (for Multi-Mode Manual Transaxle)

    Click here

17. INSPECT FOR TRANSAXLE OIL

    Click here

18. INSTALL ENGINE UNDER COVER RH

    Click here

19. INSTALL ENGINE UNDER COVER LH

    Click here

20. INSTALL CENTER ENGINE UNDER COVER

21. INSTALL FRONT WHEEL

    Torque:

    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

22. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here