PATTERN SELECT SWITCH INSPECTION

PROCEDURE


  1. INSPECT PATTERN SELECT SWITCH ASSEMBLY


    1. A01VJEXE05
      Text in Illustration
      *a

      Component without harness connected

      (Pattern Select Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      4(MSW1) - 1(MSW2) Switch ON Below 1 Ω
      Switch OFF 10 kΩ or higher

    2. Apply battery voltage across the terminals of the connector, and check the illumination condition.

      OK
      Tester Connection Standard Condition

      Battery positive (+)→ 3(MSW+)

      Battery negative (-)→ 2(MSW-)

      		 Illuminates

      If the resistance value is not as specified, replace the pattern select switch assembly.