SHIFT PADDLE SWITCH INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. CONNECT NO. 1 SWITCH WIRE


    1. Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).

    2. A01VIGGE05
      Text in Illustration
      *1 Clamp
      *a 0 to 40°
      *b

      1 to 3 mm

      (0.0394 to 0.118 in.)

      Install the 2 clamps as shown in the illustration.

    3. Engage the 6 guides to install the No. 1 switch wire.

  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)


    1. Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.

      Torque:
      1.3 N*m  { 13 kgf*cm, 12 in.*lbf }

      Note

      Make sure that the brackets are securely installed.

  3. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Shift Paddle Switch)

    Click here

  4. ADJUST SPIRAL CABLE SUB-ASSEMBLY

    Click here

  5. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  6. INSTALL STEERING PAD (for TMC Made)

    Click here

  7. INSTALL STEERING PAD (for TMMF Made)

    Click here

  8. INSTALL LOWER NO. 2 STEERING WHEEL COVER (for TMC Made)

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  10. INSPECT STEERING WHEEL CENTER POINT

  11. INSPECT SRS WARNING LIGHT

    Click here