FRONT AXLE HUB(for TMMF Made) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side as for the LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  3. REMOVE FRONT DISC

    Click here

  4. INSPECT FRONT AXLE HUB BEARING BACKLASH


    1. A01VGIU

      Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum
      0.05 mm (0.00197 in.)

      If the backlash exceeds the maximum, replace the front axle hub bearing.

  5. INSPECT FRONT AXLE HUB RUNOUT


    1. A01VM26

      Using a dial indicator, check the runout of the surface of the axle hub.

      Maximum
      0.05 mm (0.00197 in.)

      If the runout exceeds the maximum, replace the front axle hub sub-assembly and front axle hub bearing.

  6. INSTALL FRONT DISC

    Click here

  7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  8. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }