FRONT AXLE HUB BOLT(for TMMF Made) REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side as for the LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  3. REMOVE FRONT DISC

    Click here

  4. REMOVE FRONT AXLE HUB BOLT


    1. A01VM2IE04
      Text in Illustration
      *a Hold
      *b Turn

      Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.

      SST
      09628-10011

  5. INSTALL FRONT AXLE HUB BOLT


    1. A01VH5CE04
      Text in Illustration
      *1 Washer
      *2 Nut
      *a Hold
      *b Turn

      Install the washer and the nut onto a new axle hub bolt, as shown in the illustration.

      Recommended Service Nut
      Thread Diameter Thread Pitch
      12.0 mm (0.472 in.) 1.5 mm (0.0591 in.)

      Tech Tips

      Recommended thickness of the washer is 5 mm (0.197 in.) or more.

    2. Using a screwdriver or the equivalent to hold the axle hub, install the axle hub bolt by tightening the nut.

  6. INSTALL FRONT DISC

    Click here

  7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  8. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }