STEERING KNUCKLE(for TMC Made) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side as for the LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT AXLE HUB BEARING


    1. A01VDKEE01
      Text in Illustration
      *a Magnetic Rotor Side
      A01VL3H Inside of the vehicle

      Using SST and a press, insert a new axle hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.

      SST
      09950-60020   ( 09951-00710 )
      09950-70010   ( 09951-07100 )

      Note


      • Do not remove the inner race because the hub bearing is built into the oil seal.

      • Do not use bearings that have been removed.

      • Do not wipe off any grease that has been applied to new bearings.

      • Do not bring magnets close to the magnetic rotor surface of the bearing.

      • Keep the magnetic rotor surface of the bearing free of foreign matter.

  2. INSTALL FRONT DISC BRAKE DUST COVER


    1. A01VLC2E01

      Provisionally install a new disc brake dust cover, as shown in the illustration.

      Standard distance A
      19.8 mm (0.78 in.)
    2. A01VEPME01

      Using SST and a hammer, install the disc brake dust cover.

      SST
      09223-56010

      Note


      • Uniformly press in the disc brake dust cover while sliding SST slightly.

      • Press in the disc brake dust cover until it is securely seated to the pressing-in base.

    3. A01VM4M

      Using a chisel, fix the 3 points on the circumference.

      Note

      Securely fold each end into the engagement grooves.

  3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT AXLE HUB HOLE SNAP RING

    Click here

  5. INSTALL FRONT AXLE ASSEMBLY

    Click here