TRANSMISSION CONTROL CABLE INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Pass the transmission control cable into the vehicle and install the transmission control cable assembly to the body using the 4 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Install the transmission control cable assembly onto the No. 1 transmission control cable bracket with a new clip.

    3. A004AABE02
      Text in Illustration
      *a P Position
      *b R Position
      *c N Position

      Rotate the control shaft lever clockwise until it stops, and then from that position rotate it counterclockwise by 2 notches to set it to the N position.

    4. Install the transmission control cable assembly onto the transmission control shaft lever with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
    5. A004A1SE06
      Text in Illustration
      *1 Nut
      *2 Lock
      *a Rotate Approximately 180°
      *b Push In

      Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.

    6. A0049PJE02

      Install the transmission control cable to the shift lever plate.

      Text in Illustration
      *1 Lock
      *2 Shift Lever Plate
      *a Tab

      Note


      • Install the cable outer with the tab facing upwards.

      • After installation, check that the cable outer lock extends past section A as shown in the diagram.

      Tech Tips

      As shown in the illustration, the transmission control cable for LHD models passes along the left side of the projection, while the transmission control cable for RHD models passes along the right side of the projection.

      A0048VUE01
      Text in Illustration
      *A for LHD
      *B for RHD
      *1 Projection
      *2 Transmission Control Cable

    7. Confirm that the shift lever is in N, and then install the cable end to the shift lever assembly.

      Note


      • Securely install the cable end to the shift lever assembly.

      • Install the cable end so that its adjustment lock section is on the driver side.

  2. ADJUST SHIFT LEVER POSITION

    Click here

  3. INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR


    1. Install the No. 2 floor heat insulator with the 2 bolts and nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  4. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Click here

  5. INSTALL BATTERY CARRIER

    Click here

  6. INSTALL BATTERY TRAY

    Click here

  7. INSTALL BATTERY

    Click here

  8. INSTALL REAR CONSOLE BOX

    Click here

  9. INSPECT FOR EXHAUST GAS LEAK