TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. REMOVE REAR CONSOLE BOX

    Click here

  2. REMOVE BATTERY

    Click here

  3. REMOVE BATTERY TRAY

    Click here

  4. REMOVE BATTERY CARRIER

    Click here

  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  6. REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR


    1. A01VFX3

      Remove the nut and 2 bolts and front No. 2 floor heat insulator.

  7. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01VI02

      Disconnect the cable end from the shift lever assembly.

    3. A01VJQLE01
      Text in Illustration
      *1 Nut
      *a Rotate Approximately 180°
      *b Disconnect

      Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut, disconnect the transmission control cable assembly from the shift lever plate.

      Note

      Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.

    4. A01VIX1

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

    5. Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.

    6. A01VHAG

      Remove the 4 nuts and then remove the transmission control cable assembly from the vehicle exterior.