OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENSOR


    1. Apply a light coat of Toyota Genuine CVT fluid FE to the O-ring of the oil pressure sensor.

      Note

      If reusing the oil pressure sensor, check that the O-ring is not damaged.

    2. A01VJTFE01

      Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

      SST
      09268-46012
      Torque:
      29 N*m  { 300 kgf*cm, 22 ft.*lbf }

      Note

      Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the oil pressure sensor connector.

  2. INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

  3. INSTALL ENGINE UNDER COVER LH

    Click here

  4. RESET MEMORY (CVT oil pressure calibration)

    Click here