CONTINUOUSLY VARIABLE TRANSAXLE FLUID REPLACEMENT

PROCEDURE

REPLACE CVT FLUID
1. Lift the vehicle. [*1]
  
  Note
  
  Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure the tilt angle from the front to rear of the vehicle is within +/- 1°).
2. Remove the engine under cover LH.
3. Remove the refill plug and gasket from the continuously variable transaxle. [*2]
4. Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle. [*3]
5. Text in Illustration
  
  *1 No. 1 Transmission Oil Filler Tube
  
  Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the oil pan and drain the CVT fluid. [*4]
6. Measure the amount of fluid that you drained. [*5]
  
  Tech Tips
  
  Add the same amount of fluid in step 8.
7. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the oil pan. [*6]
  
  Torque:
  
  0.8 N*m { 8.2 kgf*cm, 7 in.*lbf }
8. Temporarily install the gasket and the overflow plug. [*7]
  
  Tech Tips
  
  Reuse the old gasket. The plug will be removed again to adjust the fluid level.
9. Fill fluid from the refill hole with the same amount of fluid as you drained in step 5. [*8]
  
  Note
  
  Use Toyota Genuine CVT fluid TC.
10. Temporarily install the gasket and refill plug to avoid fluid spillage. [*9]
  
  Tech Tips
  
  Reuse the old gasket. The plug will be removed again to adjust the fluid level.
11. Lower the vehicle.[*10]
12. Start the engine.[*11]
13. Slowly move shift lever from P to D, and then back to P.[*12]
14. Allow the engine to idle for 30 seconds to warm it up.[*13]
15. Turn the ignition switch off.[*14]
16. Repeat steps [*1] to [*14].
17. Repeat steps [*1] to [*10].
BLEED ELECTRIC OIL PUMP (w/ Stop And Start System)

Click here
ADJUST FLUID TEMPERATURE

Click here
ADJUST FLUID LEVEL

Click here
AFTER FILLING TRANSAXLE

Click here