TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • B0045U6

        Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

  4. REMOVE NO. 1 ENGINE COVER

    Click here

  5. DISCONNECT NO. 2 VENTILATION HOSE

    Click here

  6. SEPARATE NO. 2 VACUUM SWITCHING VALVE ASSEMBLY

    Click here

  7. DISCONNECT NO. 1 AIR HOSE

    Click here

  8. REMOVE AIR CLEANER HOSE ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  10. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  11. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  12. REMOVE BATTERY

    Click here

  13. REMOVE BATTERY TRAY

    Click here

  14. REMOVE BATTERY CARRIER

    Click here

  15. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  16. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  17. REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR


    1. B0046UQ

      Remove the nut and 2 bolts and front No. 2 floor heat insulator.

  18. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. B00484S

      Disconnect the end of the transmission control cable assembly from the shift lever assembly.

    3. B00456RC01
      *1 Nut
      B0046MU Rotate approximately 180°
      B0045SR Pull out

      Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the shift lever assembly.

      Note

      Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.

    4. B0045PP

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

    5. Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.

    6. B00474A

      Remove the 4 nuts and then remove the transmission control cable assembly from the vehicle exterior.