MULTI-MODE MANUAL TRANSAXLE SYSTEM Engine does not Start

DESCRIPTION

If any malfunctions are suspected in the transaxle control system after reassembling or repairing transaxle system components, perform troubleshooting in accordance with the following chart.

PROCEDURE

1. CHECK DTC OUTPUT

   
   

   1. Connect the intelligent tester to the DLC3.

   2. Turn the ignition switch to ON.

   3. Turn the tester on.

   4. Enter the following menus: Powertrain / Multi-Mode M/T / DTC.

   5. Read the DTCs using the tester.

      Result

      Result	Proceed to
      DTCs is not output	A
      DTC is output	B

   
   

   B

   GO TO DTC CHART Click here

   A

2. READ VALUE USING INTELLIGENT TESTER (LEARN-CLUTCH STOP POINT)

   
   

   1. Enter the following menus: Powertrain / Multi-Mode M/T / Data List / Learn-Clutch Stop Point.

   2. In accordance with the display on the tester, read the Data List.

      Result

      Result	Proceed to
      Executed (Exec)	A
      Not executed (Notexec)	B
      Failure (Fail)	C

   
   

   B

   PERFORM INITIALIZATION Click here

   C

   CHECK CLUTCH SYSTEM (GO TO EFFECT OF MULTI-MODE M/T PART MALFUNCTION ON LEARNING) Click here

   A

3. READ VALUE USING INTELLIGENT TESTER (LEARNING-T/M)

   
   

   1. Enter the following menus: Powertrain / Multi-Mode M/T / Data List / Learning-T/M.

   2. In accordance with the display on the tester, read the Data List.

      Result

      Result	Proceed to
      Executed (Exec)	A
      Not executed (Notexec)	B
      Failure (Fail)	C

   
   

   B

   PERFORM INITIALIZATION Click here

   C

   CLEAR LEARNING VALUE AND EXECUTE LEARNING AGAIN (GO TO EFFECT OF MULTI-MODE M/T PART MALFUNCTION ON LEARNING) Click here

   A

4. READ VALUE USING INTELLIGENT TESTER (GEAR POSITION (CURRENT))

   
   

   1. Enter the following menus: Powertrain / Multi-Mode M/T / Data List / Gear Position (Current).

   2. Move the shift lever to N (neutral).

   3. In accordance with the display on the tester, read the Data List.

      Result

      Result	Proceed to
      Neutral (N)	A
      Other than neutral (N)	B

   
   

   B

   CHECK TRANSAXLE ASSEMBLY (GO TO EFFECT OF MULTI-MODE M/T PART MALFUNCTION ON LEARNING) Click here

   A

5. INSPECT PARK/NEUTRAL POSITION SWITCH

   
   

   1. Inspect park/neutral position switch Click here.

   
   

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   NG

   REPLACE PARK/NEUTRAL POSITION SWITCH Click here