MULTI-MODE MANUAL TRANSAXLE SYSTEM, Diagnostic DTC:P0500

DTC Code DTC Name
P0500 Vehicle Speed Sensor "A"

DESCRIPTION

Vehicles, which are equipped with the VSC (Vehicle Stability Control System), detect the vehicle speed using the skid control ECU and wheel speed sensor. The wheel speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU converts the wheel speed signal into a 4-pulse signal and transmits it to the TCM via the combination meter. The TCM determines the vehicle speed based on the frequency of the pulse signal.

B0047KWE04
*a 4-pulse
*b From Wheel Speed Sensor
*c Skid Control ECU
*d Combination Meter
DTC No. DTC Detection Condition Trouble Area
P0500

The TCM detects the following conditions simultaneously for 4 seconds or more:

(1-trip detection logic)


  1. Vehicle is being driven: Transmission revolution sensor signal is 1650 rpm or more

  2. Vehicle speed signal is 12 km/h (7.5 mph) or less

  3. Gear is engaged

  • Wire harness or connector

  • Vehicle speed signal circuit

  • TCM

WIRING DIAGRAM

Refer to Meter/Gauge system Click here.

Tech Tips

When a DTC P0500 is output, a ground short in the wiring of terminal SPD or an internal ground short in the relevant ECU is suspected.

PROCEDURE


  1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menu : Powertrain / Multi-Mode M/T / Data List / Vehicle Speed.

    5. Drive the vehicle.

    6. In accordance with the display on the tester, read the Data List.

      OK
      Vehicle speeds displayed on tester and speedometer display are equal.

    OK

    SYMPTOM SIMULATION AND DTC CHECK Click here

    NG

  2. CHECK COMBINATION METER ASSEMBLY (SPD SIGNAL WAVEFORM)


    1. B0047JIE02
      Text In Illustration
      *a

      Component with harness connected

      (Combination Meter Assembly)

      Check the output waveform.


      1. Remove the combination meter assembly with the connector(s) still connected.

      2. Connect an oscilloscope to terminals F1-6 (+S) and body ground.

      3. Turn the ignition switch to ON.

      4. Turn the wheel slowly.

      5. Check the signal waveform according to the condition(s) in the table below.

        Item Condition
        Tool setting 5 V/DIV., 20 ms/DIV.
        Vehicle condition Driving at approx. 20 km/h (12 mph)
        OK
        The waveform is displayed as shown in the illustration.

        Tech Tips

        When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.


    NG

    GO TO METER / GAUGE SYSTEM (SPEED SIGNAL CIRCUIT) Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (TCM - COMBINATION METER)


    1. Disconnect the TCM connector.

    2. Disconnect the combination meter connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F1-6 (+S) - A47-23 (SPD) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. REPLACE TCM


    1. Replace the TCM Click here.


    NEXT

  5. PERFORM INITIALIZATION


    1. Perform the initialization and learning for multi-mode manual transaxle system Click here.


    NEXT

    END