TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

   Click here

5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click here

6. REMOVE AIR CLEANER BRACKET

   Click here

7. REMOVE BATTERY

   Click here

8. REMOVE BATTERY TRAY

   Click here

9. REMOVE BATTERY CARRIER (for LHD)

   Click here

10. REMOVE BATTERY CARRIER (for RHD)

    Click here

11. REMOVE NO. 1 AIR TUBE

    
    

    1. 

       Disengage the clamp to separate the wire harness from the No. 1 air tube.

    2. Remove the bolt and nut to separate the wire harness from the No. 1 air tube.

    3. 

       Loosen the 2 hose clamps and disconnect the No. 1 air hose and No. 2 air hose from the No. 1 air tube.

    4. Remove the 2 nuts and No. 1 air tube from the manual transaxle assembly.

12. REMOVE EXHAUST PIPE

    Click here

13. REMOVE REAR CONSOLE BOX

    Click here

14. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

15. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    
    

    1. 

       Remove the 2 A clips to separate the transmission control cable assembly from the control cable bracket.

    2. Remove the 2 B clips to disconnect the transmission control cable assembly from the manual transaxle assembly.

    3. 

       Remove the 4 nuts and transmission control cable assembly from the vehicle body.

16. REMOVE TRANSMISSION CONTROL CABLE SUPPORT

    Tech Tips

    Perform this procedure only when replacement of the transmission control cable support is necessary.

    
    

    1. 

       Remove the nut and transmission control cable support from the vehicle body.